When the glue hardens, cut the remaining part [of the stick] from behind.Make the wrap adhere to the metal washer, rubbing on it with a pad or something.~ Well then, let's start working ~Spread a bit of glue on the bottom part.Aaaargh~A little bit of glueLike this, it won't look so good, so let's make the part to fill the hole.Cut it at a little less than 1 cm.With a pad, spread the glue uniformly on the inside surface .Cut out the excess wrap with a scissor.Put a metal bead where the glue is.
Looking from above, let's adjust it and make sure it won't get dislocated.Stick it in while the glue hasn't dried yet.
The rhinestone may just barely fit the hole. When it won't, please push it in with a chopstick or something like that.Before the glue dries, put a plastic wrap of the adequate dimension on it.eeeeeek~Metal part - lower part: complete!
~continue~